Module disassembly 5
© 2000 Martin Professional A/S, Denmark
MAC 2000 Performance Service Manual
MODULE DISASSEMBLY
SEPARATE THE FRAMING/IRIS MODULE
1 To avoid damaging the iris belt when removing
and replacing, remove the iris motor gear from
the motor shaft.
2 Remove the cable guard.
3 Align the framing rotation stop with the access
hole in the framing plate.
4 Pull the springed guide wheel levers back to
release the module, you can remove springs to
make this easier, and lift out the rotating assembly.
5 Installation is the reverse. Important note:
Avoid twisting the cable bundle when
replacing the rotating assembly
.
1. cable guard
2. framing rotation stop
3. framing wheel and iris
4. framing wheel rack
5. guide-wheel levers
6. framing plate
7. gobo module
1
2
4
6
5
3
5
To Next Page
Loading...
