Module removal and installation 20
© 2000 Martin Professional A/S, Denmark
MAC 2000 Performance Service Manual
INSTALL ZOOM / FOCUS MODULE
5 Remove the 4 module fastening
screws.
6 Remove the screws that fasten the
starter to the module. You may need to
lift the module some to access the
bottom screw. Move the starter out of
the way.
7 Lift the module out of the head. Take
care not to damage the frost glass.
1 Find the 2-wire cable labelled “23” and
hold it outside the head.
2 Move the starter to the side and insert
the zoom/focus module into the head.
3 Fasten the starter to the module plate
with 2 M4 x 6 mm metric screws (Martin
P/N 08070401). You need a long
screwdriver to reach to bottom screw.
4 Fasten the zoom / focus module to the
chassis.
To Next Page
Loading...
