Martin MAC 2000 Performance - ZOOM AND FOCUS; REPLACE MOTORS

To Next Page

To Previous Page

Zoom and focus 23

MAC 2000 Performance Service Manual

ZOOM AND FOCUS

REPLACE MOTORS

1 Remove the following:

• framing module (p. 4)

• front lens ring

• front lens

• zoom / focus module (p. 19)

• effect wheel module (p. 31)

2 Unplug and free the wires for the top

and bottom fans. Unscrew and remove

both fans.

3 Unplug the focus reset switch wires

and the focus motor.

4 Unplug the zoom motor.

5 Measure the length of the zoom and

focus belt tails at the rear plate.

Unscrew the clamps on the rear plate

and release the belts.

6 Pry the shaft retaining rings off of the

back end of the focus and zoom rails.

7 Remove 8 screws fastening the rear

plate to the side plates.

8 Remove 2 screws fastening the right

side plate to the front plate. Pull the

rear plate off the zoom/focus rails.

Other manuals for Martin MAC 2000 Performance