Martin MAC 2000 Performance - Page 24

Zoom and focus 24
© 2000 Martin Professional A/S, Denmark
MAC 2000 Performance Service Manual
9 Remove the focus assembly. Install a
new motor as shown and transfer the
gear. Do not tighten the set screw.
10 Remove the zoom assembly. Remove
the larger plastic slide. Install a new
motor as shown and transfer the gear.
Do not tighten the set screw. Reinstall
the plastic slide.
11 Place the zoom assembly on the zoom
rails.
12 Place the focus assembly on the focus
rails.
13 Thread the focus belt over the rollers
and gear.
14 Install the rear and right-side plate.
Fasten with metric hardware (P/N
08070801, “M4x8 screw, Torx, cs,
black”) instead of the original taptites.
Use an M4 nut to secure the screw if
the threads are stripped.