Martin MAC 2000 Performance - Separate Gobo Module from Framing;Iris Module

Module disassembly 6
© 2000 Martin Professional A/S, Denmark
MAC 2000 Performance Service Manual
SEPARATE GOBO MODULE FROM FRAMING/IRIS
MODULE
1 Remove 5 torx screws from the module spacers. Do not remove the torx screws that
fasten the gobo rotation sensor PCB.
2 Unplug the gobo wheel sensor (29) and the gobo rotation sensor (28). Unplug the
gobo motors (1 and 2) from the connection print. Cut the strip tie securing the gobo
animation wheel motor and sensor.
3 Unfold the module.
1.gobo module
2. framing/iris module
1 2