Martin MAC 2000 Performance - ZOOM; FOCUS MODULE; REMOVE ZOOM; FOCUS MODULE

Module removal and installation 19
© 2000 Martin Professional A/S, Denmark
MAC 2000 Performance Service Manual
ZOOM / FOCUS MODULE
MODULE REMOVAL AND INSTALLATION
REMOVE ZOOM / FOCUS MODULE
1 Remove the following:
• top and bottom head covers
• front lens ring
• framing/iris/gobo module (p. 4)
2 Remove the front lens now if you are
going to replace a lens, belt, or motor.
3 At the bottom of the head, remove the
front screw from the module alignment
plates and push the plates to the side.
4 Disconnect the 2-pole cable labelled
“23” from the right side connection
block.