Effect wheel 31
© 2000 Martin Professional A/S, Denmark
MAC 2000 Performance Service Manual
EFFECT WHEEL
REMOVE EFFECT WHEEL MODULE
INSTALL EFFECT WHEEL MODULE
REPLACE EFFECT WHEEL MOTOR
1 Remove the framing module (p. 4).
2 Remove one of the effects from the
effect wheel.
3 Using a short screwdriver or
equivalent, remove the 4 screws that
fasten the effect wheel module to the
zoom / focus module.
4 Unplug the effect wheel motor as you
remove the module.
1 Plug in the effect wheel motor. Turn the
motor so that the socket points down
and insert the motor through the rear
plate of the zoom / focus module. The
triangular corner of the module plate
points towards the junction print.
2 Align the screw holes and fasten with
P/N 08070801, “M4x8 screw, Torx, cs,
black”, instead of the original taptites.
3 Install the effect in the effect wheel.
4 Install the framing module.
1 Remove the effect wheel module.
2 Loosen the set screws and pull the
effect wheel off of the motor shaft.
3 Unscrew the old motor from the plate.
Install a new motor with the plug facing
away from the triangular corner.
4 Place the effect wheel on the motor
shaft. Do not tighten the set screws.
5 Reinstall the module and adjust. (p. 33)
To Next Page
Loading...
