Effect wheel 32
© 2000 Martin Professional A/S, Denmark
MAC 2000 Performance Service Manual
REPLACE EFFECT WHEEL
REPLACE VARIABLE FROST FILTER
1 Remove the effect wheel module (p.
31).
2 Unscrew the wheel from the adaptor.
3 Place the replacement effect wheel on
the shaft adaptor and orient it as shown
with respect to the spring and set
screws. Fasten.
4 Reinstall the effect module (p. 31).
5 Transfer the effects to the new wheel. In
the standard configuration, the prism is
located next to the open position and
the wide angle lens is next to full frost.
6 Check the alignment and adjust if
necessary.
1 Remove the effect module.
2 Carefully remove the old filter and cut
away the remaining glue with a sharp
razor blade. Clean the surfaces with
alcohol.
3 Position the filter on the wheel using
the old glue line as your guide and
clamp it in place.
To Next Page
Loading...
