Martin MAC 2000 Performance - Replace Belts

Zoom and focus 26
© 2000 Martin Professional A/S, Denmark
MAC 2000 Performance Service Manual
REPLACE BELTS
22 Secure the wires at the bottom of the
module with 3 cable ties at the corners
of the fan.
23 Connect the top fan cable to the to the
2 pins closest to the starter on the
junction print labelled “38”.
24 Connect the zoom/focus microswitch
cable to the rear 3 pins of the center
socket of the right-side junction print
labelled “31”.
25 Install the effect wheel module (p. 31).
Verify that the wheel turns freely and
adjust the position of the rails if
necessary.
26 Install the zoom/focus module (p. 20).
1 If replacing the focus belt, remove
• the top head cover
• front lens ring
• front lens
• framing module (p. 4)
•top fan
2 If replacing the zoom belt, remove the
• top and bottom head covers
• front lens ring
• framing module (p. 4)
• one of the effect wheel effects