Module removal and installation 21
© 2000 Martin Professional A/S, Denmark
MAC 2000 Performance Service Manual
5 Reposition and fasten the module
alignment plates at the bottom of the
head.
6 Insert the framing module and fasten it.
7 Connect the top fan cable to the 2 pins
closest to the starter on the junction
print labelled “38”. (The left-side lamp
cooling fan connects to the other 2
pins.)
8 Connect the cable from the bottom fan
to the forward 2 pins of socket 37.
Connect cable “23” to socket “D”.
Connect the zoom/focus microswitch
cable to the rear 3 pins of the center
socket of junction print “31”.
9 Connect and secure all cables in the
left and right wire bundles.
10 Locate the 3-wire cable for the effect
wheel sensor, lead it around the top
fan, and connect it to the sensor PCB.
11 Secure the cables with cable ties at the
corners of the fan.
To Next Page
Loading...
