Stork Vitals+ Basic Setup and Use of Stork
Masimo Corporation 23 www.masimo.com
Add Stork Devices
After creating an account and baby profile, select Add Device to continue. On the next
screen, select a device that came with Stork to connect with the Stork system. If additional
devices need to be connected to Stork, see
Device Management
on page 38.
Step 2: Setting up the Stork System
After the Stork app is installed and a user account and baby profile are created, follow the
app instructions to set up your Stork System. See
Device Management
on page 38 to
connect Stork devices.
• Place the Stork Camera in a safe place, connect the camera to the app and local Wi-Fi
network.
• Charge the Stork Sensor and use the app to pair the sensor.
• Attach the sensor to the Stork Boot, and then attach the boot to the baby's foot for
monitoring.
After these items are set up, monitoring of the baby's health data begins.
Stork Camera Setup
See
Device Management
on page 38 to connect the Stork Camera and follow the app
instructions to:
• Pair the camera to the Stork app using Bluetooth.
• Connect the camera to the wireless network (Wi-Fi).
• Install the camera. The camera can be set on a flat surface (such as a dresser) or
mounted to the wall (preferred).
Connecting the Stork Camera
The Stork Camera is connected in two (2) steps.
S t e p 1: Pair the Stork app to the camera using Bluetooth.
Step 2: Connect the camera to the wireless network (Wi-Fi).
1. Plug the power cable into the camera (A), the power cable into the 12W AC power
adapter (B) and plug the power adapter into a wall socket (C).
Note: The camera Indicator is white when powered on. See Camera Status Light on
page 51.
To Next Page