Stork Vitals+ Basic Setup and Use of Stork
Masimo Corporation 25 www.masimo.com
WARNING: Do not place or mount the camera inside or on the edge of the crib to prevent
the camera from falling on the baby or the baby pulling on the power cable.
Installing the Stork Camera on a Wall
Note: Ensure the power adapter is unplugged from the wall socket before installing the
camera to the wall.
1. Plug the power cable into the bottom of the camera (A).
Press the cable down to secure it in the built-in channel (B).
2. Place the camera on wall with the center of the mount (A) 4-5 feet
above the crib mattress, near the center of the crib.
Make sure it is level and the 4 hooks a re facing up, then mark the
locations of the screw holes.
3. Drill the 2 marked locations using a 1/4" (6.35 mm) drill bit.
4. Gently tap the two wall anchors into the holes until they are flush
with the wall.
To Next Page
Loading...