Stork Vitals+ Basic Setup and Use of Stork
Masimo Corporation 29 www.masimo.com
Removing the Sensor from the Boot
To remove the sensor, push through the opening in the bottom of the boot.
Attaching the Boot to the Foot
1. Place the boot to either foot. Check for proper alignment. The boot
should be snug, but not tight.
2. Wrap the cloth straps for the boot and the sensor around the foot
and feed the straps through the openings in the boot.
3. Fold the straps over to secure to the boot to the foot. Check the
strap length. Change the straps as needed to fit your baby.
When sizing the straps for proper fit, for example, a small newborn
will most likely require the Size 2 strap at the ankle and the Size 1
strap at the sensor.
To Next Page
Loading...