82
Chapter 6, Using Matrox VS4 with StudioCoast vMix
7 Under Audio Input, select the SDI audio input pair that you want. You can
select
Embedded12, Embedded34, Embedded56, or Embedded78.
¦NoteIf you need to change the audio input source after clicking OK in the
next step, see “Changing the audio input” on page 82.
8 Click OK to apply your changes (all other Camera settings can be left at
their default settings). You should see a preview of your selected video
source play back in the
Matrox VS4 Input preview window. If you don’t
see your source video, check that your Matrox VS4 hardware and selected
video source are properly connected.
9 If you want to add more video inputs, click the Add Input button, and repeat
steps 4 to 8 for each input that you want to add.
¦NoteYou can add up to a total of four video inputs.
Changing the audio input
Once you add an input source in StudioCoast vMix, you cannot change the audio
input that was selected for it. If you need to change the audio input that you
originally selected, you must remove the video input source and add it again with
the audio input that you want as follows:
1 In the Input window, click the Close button in the appropriate Matrox VS4
Input
preview window.
2 Add the video input source again with the audio input that you want as
explained in “Selecting VS4 inputs in vMix” on page 81.
Streaming live media with vMix
To stream live media using StudioCoast vMix:
1 Select the VS4 inputs that you want to stream as explained in “Selecting
VS4 inputs in vMix” on page 81.
2 Click the Stream button on the Input Bar to specify the settings you want
for streaming to a live streaming service as explained in your vMix
documentation.
To Next Page
Loading...
