54
Chapter 4, Using the VS4Recorder Pro Application
When first opening VS4Recoder Pro, a (valid) default multicast IP address is
displayed in VS4Control, but it can be changed (an entered address will be
validated). The change must be done on all the machines connected to the same
Master.
Since the Multicast IP address is editable, anyone joining an address on a
network is part of one group session; however, you can use several addresses
within a network, where smaller groups can work independently, with their own
master and slave machines, but still part of the same network.
¡ Important In order to change the Multicast IP address, you must first disable
VS4Control.
Audio monitoring
You can monitor any audio pair from one input source by enabling audio
monitoring for the source in the corresponding source window. VS4Recorder Pro
automatically directs the selected audio pair to your computer’s sound card for
monitoring through the computer speakers.
¥Tip You can also use the VU meters to visually monitor up to eight audio
channels per source. For more information, see “VU meters” on page 50.
Enabling/disabling audio monitoring
To enable/disable audio monitoring for a source, click the Audio Monitoring
button in the corresponding source window popover (see “Source window
popover” on page 20).
Selecting the audio pair to monitor
To select the audio pair to monitor, hover the mouse pointer over an Audio
Monitoring button to open the channel selection flyout, and then click the desired
audio pair.
Audio monitoring enabled Audio monitoring disabled
To Next Page
Loading...
