Troubleshooting
8 - 10 Problems and Possible Solutions
8
The system freezes or the screen goes
dark.
The system’s power saving features have timed-out. Use the AC/DC adapter,
press the sleep (Fn + F4) key combination, or press the power button if no LEDs
are lit.
The system never goes into a power
saving mode.
Power Options features are not enabled. Go to the Windows Power Options
menu and enable the features you prefer (see “Power-Saving States” on
page 3 - 6). Make sure you have enabled Hibernate mode from the control
panel.
The Wireless LAN or Bluetooth modules
cannot be detected.
The modules are off. Check the LED indicator and/or function key indicator to
see if the WLAN/Bluetooth module is on or off (see “LED Indicators” on
page 1 - 7). If the LED indicator is off, then press the Fn + F11 (WLAN)/WLAN
Switch or Fn + F12 (Bluetooth) key combination(s) in order to enable the
modules (see Table 1 - 2, on page 1 - 9).
The PC Camera module cannot be
detected.
The module is off. Press the Fn + F10 key combination in order to enable the
module (see “Function/Hot Key Indicators” on page 1 - 9). Run the camera
application to view the camera picture.
The Wireless LAN/Bluetooth/ PC
Camera modules cannot be configured.
The driver(s) for the module(s) have not been installed. Make sure you have
installed the driver for the appropriate module (see the instructions for the
appropriate module in “Modules & Options” on page 7 - 1).
Problem Possible Cause - Solution
To Next Page
Loading...
