34
11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
NOTE: If the rear of the vehicle & Liftgate
mounting plates are galvanized,
make sure:
• Bolts are removed from top hanger
• Bolt & cover are removed from
hanger lock
3. Check if the Liftgate mounting
plates and rear of vehicle are
galvanized (FIG. 34-1). If gal-
vanized, remove 2 bolts from
top hanger on the RH mounting
plate (FIG. 34-1). Then, remove
screw and cover from hanger
lock (FIG. 34-1). Repeat for LH
mounting plate.
LIFTGATE MOUNTING
PLATES
FIG. 34-1
COVER
CAP SCREW
BOLTS
RH MOUNTING
PLATE
LH MOUNTING
PLATE
HANGER LOCK
STEP 4 - BOLT LIFTGATE TO VEHICLE - Continued
METHOD 1 - PRE-INSTALLED MOUNTING PLATES & EXTENSION
PLATE ON VEHICLE - Continued
To Next Page
Loading...
