86
11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
STEP 18 - CHECK CLEARANCE OF RUNNER PADS -
Continued
7. Ensure the bottom tandem rollers are
seated against inner column (FIG.
86-1). Next, slide the bottom pad
down against wedge until there is no
clearance between inner column and
bottom pad (FIG. 86-1). Then, back
off (slide up) bottom pad by 1 hole
position to create clearance between
pad and inner column.
BOTTOM
PAD
LH
RUNNER
BOTTOM
TANDEM
ROLLERS
WEDGE
INNER
COLUMN
ADJUSTING LOWER PAD
FIG. 86-1
8. Bolt bottom pad to LH runner
with 2 bolts and 2 lock washers
(FIG. 86-2). Torque the 2 bolts
to 9-14 lb-ft.
BOLTING LOWER PAD &
ADJUSTING UPPER PAD
FIG. 86-2
UPPER
PAD
LH
RUNNER
WEDGE
INNER
COLUMN
UPPER
TANDEM
ROLLERS
BOLT &
LOCK WASHER
(2 PLACES)
BOLT HOLES
TO ADJUST PAD
POSITION
(8 PLACES)
BOLT HOLES
TO ADJUST PAD
POSITION
(8 PLACES)
9. Unbolt upper spacer pad from LH
runner (FIG. 86-2). Keep bolts & lock
washers to reinstall.
NOTE: Keep spacer pad in place
between column & runner
after unbolting pad from
runner.
10. Ensure upper tandem rollers are
seated against inner column (FIG.
86-2). Next, slide the upper pad
up against wedge until there is no
clearance between inner column
and upper pad (FIG. 86-1). Then,
back off (slide down) lower pad by
1 hole position to create clearance
between upper pad and inner
column.
BOTTOM
PAD
To Next Page
Loading...
