Mazda 6 - To Move the Driving Position to a Programmed Position; Using a Programmed Key

2 – 10
Essential Safety Equipment
Seats
To move the driving position to a
programmed position
(Using a button on the side of the seat)
1. Make sure the parking brake is on.
2. (Automatic transaxle)
Make sure the selector lever is in the P
position.
3. Start the engine.
4. Press the programming button for the
driving position you want to call up
(button 1 or 2).
5. A beep sound is heard when the driving
position adjustment is completed.
NOTE
 
If the driving position movement is
not changed, only the beep sounds.
 
A seat position can be called up even
with the engine not running.
 
The driving position adjustment is
cancelled in the following cases:
 
Any of the seat adjustment
switches is operated.
 
The SET button is pressed.
 
Programming button 1 or 2 is
pressed.
 
The key button or button is
operated.
 
The vehicle starts moving.
 
The active driving display is
adjusted.
(Using a programmed key)
1. Unlock the doors by pressing a request
switch or the key
button.
2. After unlocking the doors, the seat
position adjustment begins within 40
seconds of opening the driver's door,
and a beep sounds when the operation
is ¿ nished.
3. Make sure the parking brake is on.
4. (Automatic transaxle)
Make sure the selector lever is in the P
position.
5. Start the engine.
6. The active driving display adjustment
begins.
NOTE
 
If there is no driving position
movement, a beep is not heard.
 
The driving position adjustment is
cancelled in the following cases:
 
Any of the seat adjustment
switches is operated.
 
The SET button is pressed.
 
Programming button 1 or 2 is
pressed.
 
The key button or button is
operated.
 
The vehicle starts moving.
 
The active driving display is
adjusted.
/C\FCA(-''(A'FKVKQPKPFD/C\FCA(-''(A'FKVKQPKPFD 