Mazda 6 - Tail Lights (Boot Lid Side;Liftgate Side) (with LED Headlights); Tail Lights Reverse Light, Rear Fog Light Replacement

6 – 58
Maintenance and Care
Owner Maintenance
*Some models.
4. Disconnect the bulb from the socket.
5. Install the new bulb in the reverse order
of the removal procedure.
Tail lights (Boot lid side/Liftgate side)
(With LED headlights)
The LED bulb cannot be replaced as a
single unit because it is an integrated unit.
The LED bulb has to be replaced with
the unit. We recommend an Authorised
Mazda Repairer when the replacement is
necessary.
Tail lights (Boot lid side/Liftgate side)
(With halogen headlights), Reverse
light, Rear fog light
*
S a l o o n
1. Make sure the ignition is switched off,
and the headlight switch is off.
2. Pull the centre of each plastic retainer
and remove the retainers and the boot
lid trim.
Removal
Installation
3. (Reverse light, Rear fog light )
Disconnect the electrical connector
from the bulb by pressing the tab on the
connector with your ¿ nger and pulling
the connector.
4. Turn the socket and bulb assembly
anticlockwise and remove it.
/C\FCA(-''(A'FKVKQPKPFD/C\FCA(-''(A'FKVKQPKPFD 