Mazda 6 - Replacing Interior Light Bulbs; Number Plate Lights Replacement; Overhead Lights;Front Map Lights, Rear Map Lights (LED Type) Replace

6 – 60
Maintenance and Care
Owner Maintenance
4. Disconnect the bulb from the socket.
Tail lights (Liftgate side)
Reverse light, Rear fog light
5. Install the new bulb in the reverse order
of the removal procedure.
Number plate lights
1. Make sure the ignition is switched off,
and the headlight switch is off.
2. Wrap a À athead screwdriver with a soft
cloth to prevent damage to the lens,
and then remove the lens by carefully
prying on the edge of the lens with a
À athead screwdriver.
3. Disconnect the bulb by pulling it out.
Saloon
Wagon
4. Install the new bulb in the reverse order
of the removal procedure.
Replacing Interior Light Bulbs
Overhead lights/Front map lights (LED
type), Rear map lights (LED type)
The LED bulb cannot be replaced as a
single unit because it is an integrated unit.
The LED bulb has to be replaced with
the unit. We recommend an Authorised
Mazda Repairer when the replacement is
necessary.
/C\FCA(-''(A'FKVKQPKPFD/C\FCA(-''(A'FKVKQPKPFD 