MCCORMICK X60.40 - Page 71

71
Instruments and Programming
4
-AfterscrollingtothecorrectcontrollertheoperatorwillpresstheMENUbuttonagaintostartthecalibrationsequence.
-Afterthecalibrationhasbeencompleted,theoperatorcanchoosetocalibrateanothercontrollerbyscrollingthrough
usingtheUPandDOWNbuttons,orcanholdtheMENUbuttonlongerthan2secondstoexittothetoplevelofthe
calibrationmenu.FromthispointtheotherpartsoftheworkingmenucanbeaccessedbyusingtheUPandDOWN
buttons.
NOTE: If the indication " - - - " appears, during calibration selection, in the area of the display where the calibration status
is shown, tje selected calibration is not available owing to some problem in the system. Ask your Dealer for help.
- Iftheclusterisalreadycalibrated,theoperatorcanchooseanothercontrollerbypressingtheUPorDOWNbuttons.
 Theorderofthecontrollerstobecalibratedisthefollowing:
Controller Display Operator NOT for the operator

 Instrumentcluster(hitchposition) ICh OK
 Transmission tc - NO
 Cabsuspension(ifequipped) CS - NO