MCCORMICK X60.40 - Tyre Size; To Change the Tyre Size

81
Instruments and Programming
4
2.1.3 Tyre size
PresstheUPbuttontogotothenextmenusection,thatisusedtosettyresizemostsuitabletoyourtractor.Theunits
aremmandtheStaticLoadedRadiusofthetyreisused.
Thisfirstscreenwillshow"0705"asthecurrentsettingusedasanexample.Thetexttyrisshownatthebottomofthe
screen.
Tochangethetyresize:
1-PresstheMENUbutton
2-Theactualtyresizewillflash(e.g.0705).
3-PressUPorDOWNtoscrollinunitsof1from0300to1033mm.
4-TosavethisnewsettingpressandholdtheMENUbuttonforlongerthan2seconds(thenumberswillstopflashing)
andpresstheUPandDOWNbuttonstoaccessotherpartsofthemenu.
- Ifthekeyisturnedtotheoffpositionbeforethenewvalueissettheoldvalueisused.
-IfthereisaDistanceTravelledvalueinthememory,itwillnotbechangedwhenthetyresizeisaltered.
Note:
Thisvaluecanalsobemodifiedbydynamiccalibration,seethecorrespondingchapter.