MCCORMICK X60.40 - Page 74

74
Instruments and Programming
-Countercouldworkintwodifferentmodes.ModeselectionisavailableintoAccessorymenu(seeAutoFunctionSettings):
ManualMode:thetimercountseverytimetheoperatoractivatesituntiltheoperatorstopsit.
AutoMode:thecounterstartsandstopstocountautomaticallywhenthehitchisdownortheRemoteimplementswitch
ison.

AutoandManualmodewillincrementthesamecountervalue.
CounterActivation:
-PushingtheMENUbuttonforlessthan2secsstarts/stopstheWorkTimer(onlyforManualmode).
-Pushingthemenubuttonforlongerthan2secondswhencounterisvisualizedandnotactiveresetstheTimer.
-Ifpushedforlongerthan2secondswhenactive,thecounterwillstop(onlyforManual mode).
-IftheUPorDOWNarrowsarepressedtochangethemenufunctionselectedwhentheTimerisactive,thecountwill
goon.
Note:
1) Only work time function will be activated in manual mode.