McHale Fusion 3 Baler & Wrapper
106
Every week
Grease PTO shaft every 60 working hours (see Section “PTO Shaft
adjustment & maintenance” on page 55)
Check for correct air pressure in the tyres
Grease table roller bearings
Every month
Grease pick-up reel shaft bearings
Grease pick-up cam clutch
Check sufficient oil level in the gear box
Every year
Clean and lubricate all moving parts of the netter unit
Drain and change gear box oil (see Section “Gear box oil” on page 51)
Clean and lubricate dispenser gears
It may become necessary from time to time to clean the dispenser rollers as they pick
up the “tack” from plastic film. Clean off with kerosene.
At the end of the wrapping season the machine should be washed and cleaned. Any
damaged paintwork should be touched up. Any maintenance or repairs should be
carried out at this stage. The electronic control box is not waterproof, so it must be
always be stored in a dry environment. All exposed hydraulic cylinder rods should be
greased. The pick-up and the cutting device area as well as the bale chamber should
be cleaned and lubricated, see “Storage” on page 109.
WARNING: Wear proper safety equipment & follow all instructions
Ensure to wear proper safety equipment at all times when working with
the machine, such as gloves, eye protection, etc. and follow all safety
decals and instructions
WARNING: Inspections in the “Danger Zone” during machine
operation require a second trained operator at the controls
McHale recommend that nobody is ever in the “Danger Zone” at any
time during machine operation, but in the event of carrying out
inspections (contrary to our safety recommendations!) when the
machine is in operation, there must always be a second operator at the
tractor controls (who is fully competent in the operation of both the tractor
and machine), in case an emergency stop action is required.
To Next Page
Loading...
