McHale Fusion 3 - Attachments; Side Tip

McHale Fusion 3 Baler & Wrapper
102
12
Attachments
12.1 Side tip
When the machine tips off the wrapped bale, the outer wrapper roller moves down to
ground level and ejects the bale. This eliminates problems associated with bales being
tipped from a height and getting damaged as they roll away.
In stalky crops or on rougher ground conditions a side tip option is available which
allows the machine to tip the bales on their ends where there is additional film.
Figure 12.a - Side tip
12.1.1 Operating the Fusion 3 side tip frame
Once the side tip frame is assembled to the Fusion 3, it will operate automatically
without any operator input. As each wrapping cycle is completed, the operator must
ensure that a clear and sufficiently large landing area is available for the bale.
12.1.2 Safety
Always ensure that there are no persons behind or around the wrapper during
operation and unloading.
12.1.3 Road transport
The Fusion 3 side tip is not to be used in fields or on roads at speeds above 20 km/hr.
It must be ascertained first that road regulations in the country of use allow you to