McHale Fusion 3 - Control Box Functions

McHale Fusion 3 Baler & Wrapper
59
7.1 Control box functions
No. Function
Manual Automatic
1
Stop button - Twist clockwise to turn
2
Menu button
3
Select Automatic Mode Select Manual Mode
4
Four soft keys (A, B, C & D) with interchangable functions (each function
relates to the corresponding option directly above it on the screen)
5
On screen function display of the four soft key buttons below
6
Net feed Hold to pause netting of the bale
Press to feed net after an error
7
No function Rewrap or resume wrapping
8
Close the chamber No function
9
Open the chamber Open chamber after a net error
Press during transfer to pause Press
once to close after a pause
10
Raises the unblock floor Press to reset after unblocking
11
Lowers the unblock floor Hold for 3 seconds to start unblock
12
Raises the bale tipping arm Press to pause tipping of the bale
13
Lowers the bale tipping arm One press to tip the bale
14
Clock
15
Status indicator
16
Net Indicator (rotates when net is being applied)
17
Crop type
18
Wrapper ring RPM
19
Displays Manual or Automatic Mode
20
Information display
21
“A” symbol displayed when Auto tip is turned on
22
Use Softkey D to toggle between Main Screen 1 & 2
23
Main Screen 1: symbols/information (alternative to Main Screen 2)
24
Main Screen 2: symbols/information (alternative to Main Screen 1)
(3
rd
symbol is visible, with knife numbers, if selectable knives is operational)