McHale Fusion 3 - Trouble Shooting; Trouble Shooting Overview; Machine Using Higher Than Expected Horse Power When Chopping; Pick Up Slip Clutch Going Off Easily

McHale Fusion 3 Baler & Wrapper
111
15
Trouble Shooting
15.1 Trouble shooting overview
This section has been compiled by McHale Service Personnel in conjunction with
McHale importers and dealers.
It outlines some common problems which can occur and acts as a quick reference
section or check list to resolve the problem. It is important to note that it outlines the
common problems and to this effect it is not exhaustive.
Should you experience additional problems which you need help with; please do not
hesitate to contact your McHale dealer.
15.1.1 Machine using higher than expected horse power
when chopping
15.1.2 Pick up slip clutch going off easily
Symptom Reason Solution
Machine using higher than
expected horse power
Knives in chopper unit are
blunt or bale density too
high
Remove the knives,
sharpen and replace
Symptom Reason Solution
Pick up slip clutch going
off easily or machine
breaking tines
Pick up set too close to
the ground
Adjust the pick up to a
higher position. Tines
should not be getting
caught in the ground.
Pick up slip clutch
going off easily
Pick up chains loose Tighten the pick up chains
See “Chain adjustments”
on page 93