McHale Fusion 3 Baler & Wrapper
110
Tighten all bolts, nuts and setscrews (Refer to Section “Tightening torque
values” on page 108)
Check air pressure of all tyres
Connect control box and inspect for correct operation of all functions (See
“Electronic Control System” on page 58)
Inspect and modify, if necessary, all machine adjustments (See “Field
Operation & Baler Adjustments” on page 85)
Check net wrapping adjustments and inspect net knife for sharpness, ensure
to wear protective clothing whenever working in this area! See “Care of the
net wrapping system” on page 40, follow instructions and carry out correct
procedure.
Inspect aluminium dispenser rollers for a build up of tack/glue, clean off using
kerosene or diesel oil and wipe rollers dry
Fill chain oil reservoir with chain oil & fit new grease cartridge, run PTO at
approx. 200 rpm and with the control box in manual mode, operate the bale tip
up and down for around 20 cycles to ensure that all chains have a new
coating of oil applied, and new grease in all bearings.
Run a simulated “bale to wrapping” cycle as described in “Simulating a “bale
to wrapping” cycle” on page 74
To Next Page
Loading...
