McHale Fusion 3 - Page 118

McHale Fusion 3 Baler & Wrapper
118
Pre-delivery inspection form
A signed copy of this form is to be retained by both the Dealer and the Customer.
PRE-DELIVERY INSPECTION (PDI)
McHale Fusion 3 Baler & Wrapper
Castlebar Road, Ballinrobe, Co. Mayo
Tel: +353 (94) 95 20300 Fax: +353 (94) 95 20356
E-mail: sales@mchale.net Web: www.mchale.net
DEALER:....................................................
Model:
McHale Fusion 3 Baler & Wrapper
Full Address:............................................... Serial No:..........................................................
.................................................................... Date Delivered:.................................................
Fitter:........................................................... Date Inspected:.................................................
CUSTOMER:...............................................
Full Address:............................................... Tel:....................................................................
.................................................................... Mobile:..............................................................
.................................................................... E-mail:...............................................................
ENSURE THAT THE TRACTOR IS OF THE CORRECT SPECIFICATION FOR THIS MACHINE
REFER TO THE OPERATOR INSTRUCTOR MANUAL BEFORE MAKING ANY ADJUSTMENTS
!
1. Check that all accessories are with the
Owner/Operator. Check Operator
Instruction Manual and Parts List.
10. Check all manual functions on the control
unit. Run machine through automatic cycle
on the control unit.
2. Ensure machine is re-assembled
correctly. (Refer to all assembly
instructions supplied)
11. Check for smooth operation of the pick-up
reel when machine is run at 540 rpm.
3. Ensure that the wheels are correctly
fitted (i.e. valve to the outside). Torque
wheel nuts correctly.
12. Check that all electrics and lights function
correctly.
4. Check for correct tyre-type, tread and
pressure.
13. Ensure netter operation and netter-knife are
running smoothly.
5. Hitch machine to tractor, then connect
PTO shaft. Adjust PTO length if
required.
14. Check dispenser ring & dispensers are
running smoothly & free from damage or
grit.
6. When hitched to tractor check that the
machine is level with the ground. Adjust
drawbar if necessary. Attach 7 pin plug
for lighting system.
15. The operator must be fully aware of all
hazards, controls (electric & hydraulic), all
functions & safety devices of both the
machine and the tractor.
7. Connect hydraulic hosing to tractor and
ensure proper hydraulic setup. Note:
Ensure free flow return to tank.
16. Ensure that the owner/operator reads the
Operator Instruction Manual and
understands fully all safety and operating
aspects of the machine as described
therein.
8. Ensure control-unit power supply is 12v
direct from battery otherwise the
machine may malfunction.
17. Instruct operator on machine maintenance,
i.e. Check chain tensions, adjustments, tyre
pressure and wheel nuts, also areas to be
greased daily along with oiler/greaser
functions.
9. Ensure that the control-unit is on the
correct programme to suit the machine
specification.
I am satisfied that the above checks have been carried out, and that the machine is complete with all accessories and manuals.
Signed:............................................................................... (Dealer) Date:..............................
Signed:............................................................................... (Owner) Date:..............................
This machine must be registered on www.mchale.net by the Dealer in order to quality for Warranty!