McHale Fusion 3 - Page 5

McHale Fusion 3 Baler & Wrapper
5
6 Baler Requirements & Preparation 39
6.1 Net requirements 39
6.2 Care of the net roll 39
6.3 Care of the net wrapping system 40
6.4 Loading & operating the netter system 40
6.5 Net cutter setting 41
6.6 Net tension bar setting 43
6.7 Chopper unit knife removal & installation 43
6.8 Automatic lubrication system 48
6.9 Gear box oil 51
6.10 Tyre inflation pressures 51
6.11 Wheel chocks 52
6.12 Drawbar and PTO shaft stand usage 52
6.13 Drawbar adjustment 54
6.14 PTO Shaft adjustment & maintenance 55
7 Electronic Control System 58
7.1 Control box functions 59
7.2 Control box features 60
7.3 Menu Structure 65
7.4 Warning messages 70
7.5 Simulating a “bale to wrapping” cycle 74
8 Wrapper Operation 75
8.1 Loading plastic film 75
8.2 Plastic film requirements 77
8.3 Wrapping process 78
8.4 Dispenser adjustment 79
8.5 Cut and hold system 79
9 Road Traffic Safety & Operation 82
9.1 Before travelling on any public roadway 82
9.2 Road transportation 83
9.3 Road transportation with side tip attached 83
9.4 ‘Break-away’ brake 84
10 Field Operation & Baler Adjustments 85
10.1 Break-in period 85
10.2 Swath preparation 85
10.3 Pick-up reel height adjustment 86
10.4 Crop guard adjustment 87
10.5 Unblocking system 87
10.6 Chopping system 88
10.7 Selectable knives 88
10.8 Bale density gauge 89
10.9 Setting chamber pre-charge pressure 89
10.10 Chamber door lock 91
10.11 Spare film holders & door latch safety 91
10.12 Adjusting pick-up float springs 92
10.13 Chain adjustments 93