McHale Fusion 3 - Page 69

McHale Fusion 3 Baler & Wrapper
69
Lube Dose
Lube dose is factory set to 3. This should be increased if it is taking a long period of
time to make the bale or in very dry and dusty conditions, as this determines the
amount of lubrication oil applied to the chains. The grease cartridge will also get used
quicker as this setting is also increased, but this is normal and the grease cartridge
does not need to be replaced until the lube alarm sounds every 300 bales.
Bale Count
The bale count menu shows five subtotal bale counts, lube count and the grand total.
The second five subtotals are accessed by pressing the soft key “F-J”. You can return
to the first set of subtotals by pressing the soft key “A-E”.
All subtotals and the lube count can be reset by pressing the reset soft key and the tick
soft key. The grand total cannot be reset.
Operator Setup
Use the following buttons to navigate the Operator Setup:
 Toggle key to move the arrow head to each of the
parameters
 + and - keys to change the value of the selected
parameter
 ESC to return to the Machine Menu
1 Dispenser Only Out of Film
Bale Count Menu Reset Total A?