5
DISASSEMBLING OF PARTS
2.4 Perform the Cleaning Cycle
To perform a cleaning cycle of every
handpiece, tube, or connector used
during the same treatment, repeat the
operations described in
Chapter 2.2 on
page 3
or in
Chapter 2.3 on page
4
depending on the device;
1
IMPORTANT: After the cleaning cycle
with the enzymatic detergent solution,
perform a new cleaning cycle with
distilled water to remove detergent
residues.
2
Once you have nished cleaning the irrigation circuit, move on to the cleaning and sterilization
of each single part.
3 DISASSEMBLING OF PARTS
Before proceeding with the cleaning procedures described in
Chapter 4 on page 9
, disconnect
all the accessories and components of the device.
WARNING: Switch the device o.
Always turn the device o via the switch,
and disconnect the power supply cable
from the power outlet and from the
device console, before performing the
cleaning and sterilization interventions.
WARNING: Supplementary
grounding cable. If present, disconnect
the supplementary grounding cable
before you perform the cleaning and
sterilization interventions.
1
off
To Next Page
Loading...
