Medisoft 870 S - Lubrication of Deck

Service Manual 800 series Rev. 1/01.07.2019
42
Medisoft RAM Italia S.r.l. - All rights reserved
6.12 - Lubrication of deck
Essential tools:
• Rubber gloves
• Iron wax
• Ram Wax HP3 Blue
• Protective gear: face mask, glasses and gloves
• Cleaning paper
This operation can only be carried out on treadmill made from 2009 with a S.N. greater than or
equal to 10143. If the bottom is older or has been treated with silicone lubricant it must be replaced.
The operation must be carried out in a ventilated environment using protective mask and rubber
gloves.
Use the roll of paper to perfectly clean the deck surface.
Connect the iron wax to the mains voltage by setting a temperature of about 100 degrees through
the adjustment knob.
With the help of the iron, melt evenly over the entire surface of the bottom about 125g
Ram Wax HP3 blue (Fig. 49), which corresponds to about half a soap.
Always with the iron wax, melt and spread evenly the wax until the wood has absorbed all the
wax it needs (Fig. 50). This operation will be completed when a thin paraffin surface is created,
indicating the full absorption of the wax.
Fig.49 Fig.50