Service Manual 800 series Rev. 1/01.07.2019
1
Medisoft RAM Italia S.r.l. - All rights reserved
1 - Introduction
This manual identifies some of the most frequent system breakdowns of the series 800 treadmills
and describes the diagnostic procedures in order to eliminate breakdowns and return the system to
its correct functioning.
It refers principally to the troubleshooting of the 800 series.
WARNING:
Before resolving any treadmill breakdowns one must check that the connector located at the base
of the right handle has been correctly screwed in during the installation phase.
The incorrect closure of the connector’s ring nut could cause contact with some pins and not with
others. This could create breakdown symptoms as described below.
To Next Page
Loading...
