Medisoft 870 S - Page 4

Service Manual 800 series Rev. 1/01.07.2019
Medisoft RAM Italia S.r.l. - All rights reserved
5.15 - Replacement contactor ....................................................................................................... 287
5.16 - Test alimentation control board ......................................................................................... 287
5.17 - Trasformer replacement ....................................................................................................... 28
5.18 - Check fuses control board ................................................................................................... 28
5.19 - Test output J9 connector ...................................................................................................... 29
5.20 - Check cable and emergency buttons.................................................................................... 29
5.21 - Security switch test .............................................................................................................. 30
6 - Diagnosis of gliding subsystem ........................................................................................... 31
6.1 - Flow chart for gliding subsystem diagnosis ........................................................................ 32
6.2 - Tautness check of drive belt ................................................................................................ 34
6.3 - Tautening of drive belt......................................................................................................... 35
6.4 - Lubrication and gliding system check ................................................................................. 35
6.5 - Tautness check of running belt ............................................................................................ 36
6.6 - Tautening of running belt .................................................................................................... 36
6.7 - Replacement of gliding system ............................................................................................ 37
6.8 - Disassembling the gliding subsystem .................................................................................. 40
6.9 - Replacing of running belt .................................................................................................... 41
6.10 - Disposal of running belt....................................................................................................... 41
6.11 - Deck Cleaning ..................................................................................................................... 41
6.12 - Lubrication of deck .............................................................................................................. 42
6.13 - Clean of rollers and control of bearings .............................................................................. 43
6.14 - Cleaning of running belt ...................................................................................................... 43
6.15 - Wear test drive belt ……………………………………………………………………….43
6.16 – Replacement of drive belt ................................................................................................... 43
6.17 - Restoring the gliding subsystem .......................................................................................... 44
7 - Maintenance planning – Critical Parts…………………………………………………….46
Annex A Transmission protocol technical specifications ............................................................. 47
7 - Maintenance planning – Critical parts…………………………………………………….46
8 - Setting RS232 command execution in MPH or Km / h ....................................................... 55
9 - List of the most important replacement parts ...................................................................... 56
10 - Electric wiring diagram ....................................................................................................... 61