Medisoft 870 S - Page 52

Service Manual 800 series Rev. 1/01.07.2019
48
Medisoft RAM Italia S.r.l. - All rights reserved
Input commands
Hex
Decimal
Description
A0
160
Start Belt - CDS enabled (Note 1)
Belt starts moving in CDS modality
A1
161
Start Belt – CDS disabled (Note 2)
Belt starts moving in no CDS modality
A2
162
Stop Belt
Belt stops
A3
163
Set Speed
Sets speed value to the next 4 bytes of ASCII Data
A4
164
Set Elevation
Sets elevation value to the next 4 bytes of ASCII Data
A5
165
Set Time
Set time to the next 4 bytes of ASCII Data
A6
166
Set Protocol
Sets the test protocol identifier to the next 2 bytes of ASCII Data
A8
168
Reset
Reset to zero the scheduled values
A9
169
Set Patient Weight
Sets the patient weight to the next 4 bytes of ASCII Data
AA
170
Auto Stop
Sets speed and elevation to minimum and stop the belt
AB
171
Auto Cool Down
Sets speed and elevation to minimum
AC
172
Reset TADF (Transmit Acknowledge Data Flag)
See Note 3.