Meggitt vibro-meter VM600 - Page 43

QUICK START MANUAL Document reference MAVM600MK2MPS-QS/E
VM600
Mk2
machinery protection system (MPS) Edition 2 - February 2021
2-3
MPC4
Mk2
machinery protection and condition monitoring module
OVERVIEW OF VM600
Mk2
MACHINERY PROTECTION SYSTEM (MPS) HARDWARE
As shown in Figure 2-1, a MPC4
Mk2
module has the following LED indicators:
• DIAG/STATUS LED
In general, this LED is a system/module-level indicator used to indicate the status of the
VM600
Mk2
MPS (MPC4
Mk2
+IOC
Mk2
module).
•CHn (dynamic channel) LEDs – CH1, C2, CH3 and CH4
In general, these LEDs are channel-level indicators used to indicate the status of the
MPC4
Mk2
module’s dynamic channels and measurements.
•AXn (auxiliary channel) LEDs – AX1 and AX2
In general, these LEDs are channel-level indicators used to indicate the status of the
MPC4
Mk2
module’s auxiliary channels and measurements.
•LOCK LED
This LED is a safety-level indicator used to indicate the main operating mode of the
VM600
Mk2
MPS (MPC4
Mk2
+IOC
Mk2
module): Locked (safety/secure operating mode)
or Unlocked (maintenance operating mode)
For further information on the MPC4
Mk2
module’s LEDs, see 2.2.1 MPC4
Mk2
module LEDs.
As shown in Figure 2-1, a MPC4
Mk2
module has the following buttons (control inputs):
•Button 1
•Button 2
• RESET (buttons 1 and 2 together).
These buttons are used to change/control the operation and behaviour of the
VM600
Mk2
MPS (MPC4
Mk2
+IOC
Mk2
module).
For further information on the MPC4
Mk2
module’s buttons, see 2.2.2 MPC4
Mk2
module
buttons.