FOCKE MELER GLUING SOLUTIONS TABLE OF CONTENTS
‘1. Heating’ Menu 4-13
1.1 Heating zones 4-13
1.2 Sequential Heating 4-14
1.3 Inhibitions 4-14
1.4 Auto Standby - OFF 4-15
1.5 Heating Extra settings 4-16
‘2. Extra settings’ Menu 4-17
2.1 Password management 4-17
2.2 Extra settings 4-18
2.3 Configuration of input and output signals 4-19
2.4 Restore default values 4-19
‘3. Statistics’ Menu 4-20
‘4. Load’ Menu 4-20
Screen 1: Minimum adhesive level sensor 4-20
Screen 2: Automatic adhesive feeder 4-20
Automatic pumping block function 4-21
‘Automatic pumping block’ enabled 4-21
‘Automatic pumping block’ disabled 4-22
‘Off after reset’ function 4-23
‘Off after reset’ enabled 4-23
‘Off after reset’ disabled 4-24
Configuration of turning on and activating pumping 4-24
Wireless communication (Wi-Fi) 4-26
Connection configuration 4-26
Flowmeter 4-27
System calibration 4-27
Calculating the adhesive density 4-28
Product configuration 4-28
Product selection 4-30
Flowmeter statistics 4-31
To Next Page
Loading...
