Meler Micron+ Series - Page 7

MA-5162-ENG MICRON
+
PISTON ADHESIVE MELTERTABLE OF CONTENTS
Standby function 4-32
Turning off the melter equipment 4-32
Use of the automatic feeder 4-33
Start up and automatic process 4-33
Sensitivity adjustment 4-34
Positioning of the level sensor 4-34
Application for PC 4-35
5. MAINTENANCE 5-1
Equipment cleaning 5-1
System depressurisation 5-2
Access to pneumatic unit 5-3
Maintenance of the filters 5-3
Changing the pump filter 5-3
Changing the inlet filter 5-4
Cleaning the tank 5-5
Changing adhesive type. 5-5
Cleaning burnt adhesive 5-5
Emptying the tank 5-6
Safety Thermostat 5-7
Remove the equipment from its base 5-7
Automatic feeder maintenance
5-8
Cleaning of the unit 5-8
Pneumatic system 5-8
Control of the load sensor 5-9
Inspection of the aspiration tube 5-9
Filter maintenance 5-9
Control of pneumatic vibrator 5-9