Mercury 90 Service Manual

90-830234R3 DECEMBER 1997 IMPORTANT INFORMATION - 1D-9
NOTE: The rubber grommet has to be lubricated to
ease installation.
f
f
f – Lubricant
Connecting Remote Wiring
Harness To The Engine
1. Pull up the cowl seal (a) and remove the star-
board side rubber grommet (b).
b
a
2. Take hold of the engine connector (c) and install
the remote wiring harness plug (d). Connect
additional wire leads (if equipped) as shown.
NOTE: The rubber grommet can to be lubricated to
ease installation.
c
d

Mercury 90 Specifications

General

Brand	Mercury
Model	90
Category	Outboard Motor
Language	English