6A-32 - LOWER UNIT 90-830234R3 DECEMBER 1997
7. Install components as shown.
b
a
7
7
Loctite 271 (92-809820)
19217
a - Water Pump Base
b - Bolts and Washers; Apply Loctite 271 on bottom 1/2 of
Threads and Torque to 60 lb. in. (6.8 N·m)
8. Install gasket and plate.
b
a
19219
a - Gasket
b - Plate
IMPORTANT: If the old impeller will be re-used,
impeller must be installed in original (clockwise)
direction of rotation.
52869
9. Install gasket, drive key and impeller.
c
b
a
19220
a - Gasket
b - Drive Key
c - Impeller
10. Lubricate I.D. of cover with Quicksilver 2-4-C w/
Teflon.
11. Rotate drive shaft clockwise and push cover
down over impeller.
12. Install cover.
13. If water tube seal stayed on water tube (inside of
drive shaft housing) when gear housing was re-
moved, pull water tube seal from water tube.
14. Lubricate I.D. of water tube seal with Quicksilver
2-4-C w/Teflon and install as shown.
a
b
c
7
95
95
7
Loctite 271 (92-809820)
95
2-4-C With Teflon
92-825407A12
19212
a - Cover
b - Seal
c - Bolts (4); Apply Loctite 271 on Threads and Torque to
60 lb. in. (6.8 N·m).
NOTE: It is recommended that the gearcase be pres-
sure tested for leaks after reassembly and BEFORE
gear lube is added. Gearcase should hold 10 to 12
psi(68-82kPa) for 5 minutes.
To Next Page
Loading...
Need help?
General
