GASOLINE ENGINES BRAVO MODELS
Page 90 of 116
Test Running Engine
WARNING
If engine is to be tested with boat out of water, the propeller must be removed to
avoid injury.
IMPORTANT: If using a test tank, ensure water level is above water intake holes.
70082
a
b
Typical
a-Minimum Water Level
b-Water Intake Holes
IMPORTANT: If using flush test device, install over water intake holes and connect
a water hose as shown. Do not use full water tap pressure. Also, do not run engine
above 1500 rpm, as suction created could cause water hose to collapse causing
water supply to be cut off.
70564
a
b
a-Flush Test Device
b-Water Hose Hook-Up
To Next Page
Loading...
