GASOLINE ENGINES BRAVO MODELS
Page 92 of 116
11. Check power steering fluid level.
a. Turn off engine.
b. Remove cap/dipstick from power steering pump. Check fluid level and add as nec-
essary.
71672
a
b
a-Dipstick (Full When Cold Line)
b-Dipstick (Full When Hot
Line)
Boat-ln-The-Water Tests
ENGINE IDLE SPEED (ALL EFI MODELS)
CAUTION
Avoid engine damage. Ensure that cooling water is supplied to the engine if it will
be run with boat out of the water. See instructions in the Operation, Maintenance
and Warranty Manual entitled “Flushing Cooling System” for instructions on con-
necting flush device.
Engine should idle at rpm (as specified in“Operation, Maintenance and Warranty Manual)
with engine at normal operating temperature. If idle speed is incorrect, proceed as follows:
1. Ensure that throttle cable has been adjusted properly.
2. If idle speed is still not correct, it may be necessary to perform EFI System Diagnostic
Tests on the idle circuit. Refer to the appropriate Mercury MerCruiser Service Manual
for procedures.
To Next Page
Loading...
