GASOLINE ENGINES BRAVO MODELS
Page 87 of 116
Power Steering Fluid
IMPORTANT: Use only Quicksilver Power Trim and Steering Fluid or Dexron III auto-
matic transmission fluid (ATF) in power steering system.
CAUTION
DO NOT RUN POWER STEERING DRY, or pump will be damaged.
1. Position sterndrive unit so that it is straight back.
2. Remove fill cap from power steering pump reservoir and check fluid level.
3. Add fluid as required.
NOTE: When first starting engine, be prepared to add fluid to pump.
71672
76859
a
a
b
a-Fill Cap
b-Dipstick
Propeller Installation (Bravo One and Two)
IMPORTANT: Correct rotation propeller MUST match direction of rotation of propeller
shaft.
WARNING
Be sure that remote control is in neutral position and ignition key is removed from
switch prior to installing propeller.
WARNING
Place a block of wood between the anti-ventilation plate and propeller to protect
hands from propeller blades and to prevent propeller from turning when tightening
propeller nut.
1. To aid in future removal of the propeller, liberally coat propeller shaft splines with one
of the following Quicksilver lubricants.
• Special Lubricant 101
• 2-4-C Marine Lubricant with Teflon
IMPORTANT: Installation is correct when at least 2 threads of propeller shaft are
exposed through propeller nut after torquing it.
To Next Page
Loading...
