GASOLINE ENGINES BRAVO MODELS
Page 99 of 116
7. Crank engine over slightly with starter motor to purge any water trapped in seawater
pickup pump. DO NOT allow engine to start.
8. Make sure gear housing water vent and drain holes, speedometer pitot hole and trim
tab cavity vent and drain holes are open and unobstructed.
71216
a
b
c
d
a-Vent Holes
b-Trim Tab Cavity Drain Holes
c-Drain Hole
d-Speedometer Pitot Hole
9. After seawater section of cooling system has been drained completely, reinstall all com-
ponents. Reconnect all hoses and tighten hose clamps securely.
Store boat with sterndrive unit in full DOWN/IN position.
To Next Page
Loading...
Need help?
General