Appendix A: FAQ (Frequently Asked Questions)
Q1. What should I do if the login window does not appear?
Make sure the router connects to the computer correctly.
If the computer is set to a static IP address, change its settings to obtain an IP address
automatically.
Verify that http://mwlogin.net is correctly entered in the web browser.
Use another web browser and try again.
Reboot your router and try again.
Disable and enable the network adapter in use again.
Q2. What should I cannot access the internet?
Check if the internet is working properly by connecting a computer directly to the modem via
an Ethernet cable. If it is not, contact your internet service provider
Reboot your router and try again.
Open a web browser, enter http://mwlogin.net and run the Quick Setup again.
For cable modem users, reboot the modem first. If the problem persists, log in to the web
management page of the router to clone MAC address.
Q3. How do I restore my router’s configuration to its factory default settings?
There are two ways to reset the router.
Method one: With the router powered on, press and hold the RESET/WPS button for at least 5
seconds until the LED starts blinking quickly, then release the button and wait the router to reboot
to its factory default settings.
Method two: Visit http://mwlogin.net, go to Advanced→System Tools→Factory Default
Restore to restore the router to its default settings.