Mercusys MW305R - LAN Settings; LAN IP Settings

MW305R
300Mbps Wireless N Router User Guide
5.1.2 LAN Settings
Go to Network
→
LAN Settings, you can configure the IP parameters of the LAN on the screen as
below.
 MAC Address - The physical address of the router, as seen from the LAN. The value can't be
changed.
 LAN IP Settings - Select Auto or Manual. In Auto mode, the router will automatically detect
the LAN-WAN IP address confliction.
 IP Address - Enter the IP address of your router.
 Subnet Mask - An address code that determines the size of the network. Normally use
255.255.255.0 as the subnet mask.
5.1.3 IPTV
Go to Network
→
IPTV, you can configure IPTV setup to enable IPTV service provided by your
ISP.
NOTE:
1) If you
change the LAN IP address, you must use the new IP address to log in to the router.
2)
If the new LAN IP address you set is not in the same subnet with the previous one, the IP
Address pool in the DHCP server will be configured automatically, but the Virtual
Server
and DMZ Host will not take effect until they are re-configured.
- 22 -