Metrohm 899 Coulometer - Connecting an Additional Stirrer

4.5 Connecting an additional stirrer
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
22
￭￭￭￭￭￭￭￭
899 Coulometer
4.5 Connecting an additional stirrer
Instead of the built-in magnetic stirrer, you can use the magnetic stirrers
801 Stirrer or 803 Ti Stand.
Proceed as follows:
1
Switch off the coulometer.
2
Connect the connection cable of the magnetic stirrer to MSB 1 on
the rear of the coulometer.
Figure 16 Connecting a stirrer
NOTE
Make sure that the flat side of the plug matches the marking on
the socket.
3
Switch on the coulometer.