© Microhard Systems Inc. Confidential 4
Important User Information (continued)
Regulatory Requirements
To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation distance
of 23cm or more should be maintained between the antenna of this device and persons during
device operation. To ensure compliance, operation at closer than this distance is not
recommended. The antenna being used for this transmitter must not be co-located in conjunction
with any other antenna or transmitter.
This device can only be used with antennas designed for use with 900 MHz products. Please
contact Microhard Systems Inc. if you need more information or would like to order an antenna.
WARNING
MAXIMUM EIRP
FCC Regulations allow up to 36dBm Effective Isotropic Radiated Power (EIRP). Therefore, the
sum of the transmitted power (in dBm), the cabling loss and the antenna gain cannot exceed
36dBm.
WARNING
EQUIPMENT LABELING
This device has been modularly approved. The manufacturer, product name, and FCC and
Industry Canada identifiers of this product must appear on the outside label of the end-user
equipment.
WARNING
FCCID: NS913P900
IC: 3143A-13P900
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received including interference that may cause
undesired operation.
Please Note: These are only sample labels; different products contain different identifiers. The
actual identifiers should be seen on your devices if applicable.
SAMPLE LABEL REQUIREMENT:
For P900
To Next Page
Loading...
